Recent Submissions

  • CONTROL OF BIOMASS BOILER WATER TEMPERATUR USING SLIDING MODE CONTROL SYSTEM 

    Lesewed, Ali A (The International Journal of Engineering and Information Technology, 2018-06)
    Medium scale biomass temperature control is a specific field of control issues where one of the most important features is cost effectiveness. It means that any kind of control system improvement should be done with the ...
  • Development of a Clothing Sizing System for Benghazian Children Based on Anthropometric Measurements 

    Bilhassan, S; ELMABROK, A; ELMEHASHHSH, K; Ali, H; Kaddom, A; Elhouni, H (The International Journal of Engineering and Information Technology, 2018-06)
    the current study is the second step towards the overall objective of development of a clothing sizing system for Libyan children based on anthropometric body measurements of Libyan school children. The aim of this paper ...
  • Modeling and Forecasting Short-Term Electricity Demand for Libyan Electric Network 

    Khamaira, Mahmoud Y; Krzma, Adnan S; Jaba, I; Alnass, A (The International Journal of Engineering and Information Technology, 2018-06)
    Electrical load forecasting is a method of guessing the future of the electricity demand. Load forecast is an essential factor for power system planners and demand controllers. This is to ensure that would be an adequate ...
  • Prediction of Water Production Rate Using Fuzzy Logic Approach 

    Amaitik, Saleh M; Omar, Ramadan A (The International Journal of Engineering and Information Technology, 2018-06)
    —this paper describes a fuzzy expert system approach for prediction of water production rate in a desalination plant. The goal of the study is to predict water production rate based on several inlet variables determined ...
  • The Influence of Different Parameters on the Electro Refining of Copper 

    Maatgi, Musbah Kharis; Al-Zubi, Omar M; Bheej, Hussan A (The International Journal of Engineering and Information Technology, 2018-12)
    The experiments were performed using the acidic electrolyte composed of copper sulphate and sulphuric acid. The electro refining process was carried out at the temperatures of 40, 50, and 650C. On the basis of the experiments ...
  • Three Phase Two-Arm Hybrid Active Filter Using Two Feedforward Loops with Self Tuning Filter for Elimination of 5th and 7th Harmonic Frequency 

    Saleem, Mohamed Muftah (The International Journal of Engineering and Information Technology, 2018-06)
    A novel topology for three-phase three-wire hybrid power filter with two-arm is proposed, this hybrid filter configured by a classical active filter consisting of twoarm bridge using two power electronic switches for each ...
  • Steganography Technique to Hide a Secret Message in QR Code 

    Elhawil, A.; Alsellami, A.; Talha, S. A; Mohamed, I; Awein, R (The International Journal of Engineering and Information Technology, 2018-06)
    This paper proposes a new method to hide a message in Quick Response code (QR code). This type of image steganography is quite a challenge because the secrete message should not be detected by the standard QR code reader. ...
  • Effect of Heat Exposure Time on Tensile Properties in Cold Rolled Steel 

    Alzreedy, Ali M; Blaow, Mohamed M; BenRamadan, M.; Masly, F. (The International Journal of Engineering and Information Technology, 2018-06)
    This paper presents the effect of heat exposure time on tensile strength of cold rolled specimens. Welding and process annealing are applied to the specimens to investigate their implications. The two processes involve ...
  • Transient Stability of Synchronous Generator Connected to Micro Combined Heat and Power 

    Rafa, Adel Hamad (The International Journal of Engineering and Information Technology, 2018-06)
    Micro Combined Heat and Power (Micro CHP) refers to small-scale installations that generate heat, electricity or both connected to the low voltage distribution network at the customer side. Although the connection of the ...